Zooz ZEN75 Heavy Duty Switch *New*

https://www.getzooz.com/zen75-heavy-duty-wall-switch/

I’m not sure how I missed this one, but I think (?) this is a new product for Zooz.

For those of you that have used a lot of Zooz switches as I have, you’ll recall that many of their switches are limited in the types of loads they can control. However the ZEN75 helps hugely in this case, as it can support the following load types:

  • Maximum Loads: : 600W LED, 1800W Incandescent, 15 A Resistive / Tungsten / Incandescent, 10 A Inductive Ballast / Electronic Ballast / LED, 1 HP at 120 VAC / 3 HP at 240 VAC Motor

(Great for those bathroom exhaust fans that previously were only controllable by a ZEN30’s secondary relay.)

I was lucky enough to snag one before they went out of stock, and I’ll be installing this weekend. I’ll let everyone know how it goes.

Rating: -pending-

Note: It is new, so Home Assistant did not recognize it, but it is working and controllable. I’ll also be adding it to the Qolsys IQ4 panel (and alarm.com) this weekend as a test.